Cylinder (corded).
Never clean the filters with hot water, cleaning products, a dishwasher, or a machine wash..Step 4: Allow the Filters Time to Dry Fully.
It’s essential that the filters are both completely dry before you place them back into the filter frame.You don’t want to risk water being sucked into the motor, as this can cause permanent damage.. Filters typically take around 24 hours to dry after being washed.They may take longer in humid or cold environments though, so double-check that the filter is completely dry before moving to the next step..
In the CH950UKT manual, Shark specifically mentions that you shouldn’t use a hair dryer (or any other drying tool) to speed up the process.The filters should only be air-dried..
Step 5: Re-Assemble The CH950UKT.
Once the filters are dry, you can put them back into the filter frame.There’s no rotating brush bar, but this is offset by the vacuum’s strong suction power..
Unfortunately, we don’t think it’s quite as good as previous Numatic floorheads, mainly due to the new two-wheel design rather than a rear roller.We also don’t think it feels quite as sturdy as previous versions..
hard floor nozzle.is a simple tool with soft brushes that help to pick up the dirt rather than scattering it across the floor.