To access the filter, you need to take off the lid of your.
It’s important to make sure these are both unclogged, otherwise the amount of air flowing through the vacuum is greatly reduced..The first filter is located at the top of the cyclones.
You can remove it by detaching the dust canister, then pressing a latch to access the tubular filter.Rinse it in cold water until it runs clear, squeeze out excess liquid, then allow it to fully dry..The second filter is located inside the ball itself.
To access it, you’ll need to lie the vacuum on its back and unscrew the side of the ball.The filter is actually two parts – a foam ring and an outer shell – and you should separate these to wash separately.
Again, you can rinse the filter with cold water, but.
squeeze dry this filter.. As a general rule, Dyson recommends cleaning both filters on the Ball Animal 2 at least once each month.. You should always allow the filters to try for at least 24 hours before you put them back into the vacuum cleaner.As baking soda can damage your vacuum and even cause your carpets to look worn, we don’t recommend using it for cleaning carpets.
Here are some alternative tips for keeping your carpets and floors clean:.Make sure that you.
regularly vacuum your home.start to form when dirt or grime sits in carpets for long periods, which allows bacteria to multiply.